Dino V2 - Dual Motor ESC

The Dino V2 is the new version of the acclaimed Dino controller. It is a controller for two motors, optimized for use with radio control and its receivers. This board is suitable for small and mini robots (antweight), mini remote control cars, and other models.

With this electronics, it is possible to control two brushed DC motors, each up to 1.1A continuous. The peak current is 2.8A, and it can operate for a few seconds. This board has thermal protection, meaning you won't have to worry about burning due to accidental stalls .

It has a 5V BEC; therefore, it can power a microcontroller or the radio control receiver itself through the signal cables. It also has an LED for channel status indication.

Dino now has reverse polarity protection , making it even more robust! In its new version, it allows three modes of use:

• Mixed Mode: one channel controls the robot's movement, while the other controls the turns (this mode is the default on the board; just leave the pads on the back of the board unsoldered).
• Tank mode: each channel controls one of the motors independently (to activate this mode, solder the TANK and CENTRAL pins on the back of the board).
• Mirror mode: both outputs respond to a single channel, perfect for controlling two motors with just one of the radio sticks (to activate this mode, solder the MIRROR and CENTRAL pins on the back of the board).

The board also features new voltage regulators and filters to ensure full and stable operation. Its use is very simple. As it comes pre-programmed, just connect it as shown in the image below to use the driver.



Basic connection example
The board's LED indicates the state as follows:

• Constant on: channels A and B with signal
• Blinking once: channel A without signal
• Blinking twice: channel B without signal
• Blinking three times: channels A and B without signal

Specifications

• Two independent outputs for motor control (or resistive loads up to 1A).
• Supply voltage: 6V to 15V (2S and 3S LiPo batteries)
• Current: 1.1A continuous per channel (2.8A peak)
• BEC voltage: 5V
• BEC current: 150mA
• Input signal: radio control (PPM)
• Control modes: Mixer, Tank and Mirror
• Thermal protection
• Reverse power protection
• Has Fail-Safe: Yes
• Dimensions: 25 x 15mm
• Comes with soldered cables: No, as there is the possibility of using with cables, male or female pin bars.
• Weight: 5g

Boa tarde! É possível disponibilizar o esquemático e o 3d da placa? Agradeço!

Olá! Gostaríamos de informar que adicionamos o modelo 3D da placa na descrição do produto. Sendo assim, você já pode usá-lo como referência.

bom  dia  sres
Eu    comprei  o Kit  do  Tanque  e  vi  no  vídeo  que  tem um  produtos  interessantes ,  gostaria  que vc  fizessem videos de  aplicação básica   assim   desenvolvemos    nossos  conhecimentos  com  estes novos  produtos.
um  abraço  e  fico na  espera  de  novos  videos  de  aplicação

Agradecemos pela sugestão, iremos avaliar a melhor maneira de gravar o vídeo da aplicação básica. Fique por dentro das nossas redes sociais para ser avisado quando o vídeo estiver disponível para assistir.